nitehawkarchery.com

Presses bows no matter what its limb configuration;
split, parallel, or solid. Exceptions are limbs 1&3/8
inches or less at the cams. It will press the Drenalin.
Presses the entire limb using only a fraction of the
force other presses use
Presses from outside the bow offering greater safety
and access
Provides total control over the pressing process

Simple and quick to use
Uses the same procedure to press all bows
Requires no assembly or adapters
Presses with sights and stabilizer attached

Protects your bow
Uses less force than other bow presses
All contact points are rubber coated
Does not attach to the riser
Does not use cables

Has greater capabilities than any other press
Presses bows up to 95 pounds
Weighs less than 25 ounces
Has over 7 inches of travel so you can change limbs.
Carry pouch available

The Nite Hawk Press is the most versatile and easiest
press to use. It has
adjustable pin placements to adapt to the thickness
and angle of the limbs. (1)
adjustable pressure points to work around any limb
attachments. (2)
adjustable end stops to allow for cam stops. (3)
This allows you to easily work around any kind of limb
attachments.

There is little risk of over pressing your bow with a Nite Hawk Press. It presses at the axle
and not between the cams and the riser. This is so true of an X-Force & the Bowtech where
the limbs flex to the axles. With a conventional press that flex must be removed by pressing
the limbs until the end of the limb straitens out. The only way conventional press can do this is
to over press the section of the limb between the riser and the point they are pressing against.
Note green line on photo. This is how far a conventional press must force the limb to get rid of
the flex between the point they are pressing against and the axel.

The Nite Hawk Press presses at the tips of the limbs, in the same way as the cables. It does
not allow any of the limb to relax, note limb in photo. The entire limb is pressed. The Nite
Hawk Press is designed to simulate the actions of the cables.

Is there a better way of pressing a bow then to copy the normal actions of the bow? This is
what the Nite Hawk Press is designed to do.

To understand completely you should watch the video.

By both pressing at the tips of the limbs
and by floating on the limbs it reduces the
pressure needed to press a bow. It
simulates the actions of the cables.
Look at the photo of the X-Force.

In the example, Nite Hawk Press exerts
only 180# at the axel to press the X-Force,
yet all conventional presses use at least
334#. I say "at least", because
conventional presses clamp to the riser,
which can add even greater forces to the
riser and the limbs. Since the Nite Hawk
Press floats with the bow it uses only the
force needed to press the bow, which is
equal to the force the cables apply to the
limbs.

"I have to say I just received mine and can tell you it is the best press I have
used in a long time. I wasn't sure if I would like it but it is truly a nice
design. It takes very little pressure to press, I was shocked. I have used
many types and this works great. You can leave your limb savers in and
don't have to worry about ruining your limb decals. If you haven't tried one
it is hard to believe. I'm glad I did."

Dan Slaugenhoup from Archery Talk